Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
D
B
Motion
®
ual
rite
Sensor Light Control
Model 5797
Meets the ENERGY STAR
when D
ON-TIME is 1 or 5 minutes.
Features
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• Three lamp modes available: Normal, Soft, or Flash.
• D
B
Timer.
®
ual
rite
• Photocell keeps the lighting off during daylight
hours.
• LED indicates motion was sensed (day or night).
This package includes:
Plastic Hanger
Rubber Plug
Cover Plate
Light Control
Mounting Bolt
Mounting Strap
Light Shield
2 Halogen Bulbs
(Installed)
© 2007 HeathCo LLC
All manuals and user guides at all-guides.com
guidelines
®
B
function is off and
®
ual
rite
6 Mounting
Screws (3 sizes)
2 Wire
Connectors
Sensor
Gasket
Requirements
• The light control requires 120-volts AC.
• If you want to use Manual Mode, the control must be
wired through a switch.
• Some codes require installation by a qualified
electrician.
• This product is intended for use with the enclosed
gasket and with a junction box marked for use in wet
locations.
OPERATION
Mode:
On-Time:
Test
5 Sec
Normal
1, 5, 20 min.
Manual
Until Dawn*
Accent
3, 6 Hr. to Dawn
* resets to Auto Mode at dawn.
Note: When first turned on wait about 1
the circuitry to calibrate.
TEST
Put ON-TIME switch
on the sensor bottom
to TEST and the D
-
ual
B
®
switch OFF.
rite
LAMP MODE
Put the LAMP MODE switch
in the Normal, Soft, or Flash
position.
AUTO
Put the ON-TIME switch in the 1, 5,
or 20 minute position.
Works:
Day
Night
x
x
x
x
x
/
minutes for
1
2
ON-TIME
D
B
®
ual
rite
TEST 1 5 20
Off 3 6 Dusk to
Dawn
LAMP MODE
NORMAL SOFT FLASH
ON-TIME
TEST 1 5 20
598-1315-02
Publicité
Manuels Connexes pour Heath Zenith DualBrite 5797
Sommaire des Matières pour Heath Zenith DualBrite 5797
- Page 1 All manuals and user guides at all-guides.com Requirements • The light control requires 120-volts AC. • If you want to use Manual Mode, the control must be wired through a switch. Motion ® rite • Some codes require installation by a qualified electrician.
- Page 2 All manuals and user guides at all-guides.com INSTALLATION MANUAL MODE For easy installation, select an existing light operated Manual mode only works at night by a wall switch for replacement. because daylight returns the sensor to AUTO. For best performance, mount the fixture about 8 ft. (2.4 m) above the ground.
- Page 3 All manuals and user guides at all-guides.com Bulb Installation Mount the Light Control NOTE: When re-lamping, turn power off and let the ❒ Place the mounting bolt through the front of the fixture cool. junction box cover. Push the small gasket hole over ❒...
- Page 4 All manuals and user guides at all-guides.com TEST AND ADJUSTMENT NOTE: If fixture is mounted higher than 8 ft. (2.4 m), aiming the sensor down will reduce coverage distance. ❒ Turn on the circuit breaker and light switch. The detector is less sensitive to motion directly towards it. NOTE: Sensor has a 1 minute warm up period before it will detect motion.
- Page 5 All manuals and user guides at all-guides.com SPECIFICATIONS Range ... . Up to 70 ft. (21 m); 100 ft. (30.5 m) with Range Boost. [var ies with surrounding temperature] Sensing Angle ..Up to 270° Electrical Load .
- Page 6 All manuals and user guides at all-guides.com TECHNICAL SERvICE Please call 1-800-858-8501 (English speaking only) for assistance before returning product to store. If you experience a problem, follow this guide. You may also want to visit our Web site at: www.hzsupport.com. If the problem persists, call* for assistance at 1-800-858-8501 (English speaking only), 7:30 AM to 4:30 PM CST (M-F).
- Page 7 All manuals and user guides at all-guides.com Requisitos • El Control de Luz requiere 120 VCA. • Para usar el Sobrecontrol Manual, conecte el control con un interruptor. Control de luz y • Algunos códigos requieren instalación por un electricista calificado. detector de movimiento •...
- Page 8 All manuals and user guides at all-guides.com INSTALACION Para MODO MANUAL: Para una fácil instalación escoja una luz con un El modo manual funciona sólo por la interruptor de pared. noche porque la luz del día pone al Para un mejor funcionamiento, instale el aparato a casi detector en modo AUTOMATICO.
- Page 9 All manuals and user guides at all-guides.com Instalación de Bombilla Instale el Control de Luz NOTA: Cuando cambie la bombilla, apague la energía ❒ Ponga el perno de montaje a través del frente de y deje que el aparato se enfríe. la tapa de la caja de empalme.
- Page 10 All manuals and user guides at all-guides.com PRUEBA Y AJUSTE NOTA: Si el aparato está instalado a más de 8 pies (2,4 m), si se apunta el detector hacia abajo se reducirá la ❒ Prenda el cortacircuitos y el interruptor de luz. distancia de cobertura.
- Page 11 All manuals and user guides at all-guides.com ESPECIFICACIONES Fases de Lámpara . . . Normal, Suave, Destello Retardo de Tiempo . . 1, 5, 20 minutos Alcance ... Hasta 21 m, Aumento de Distancia Lámpara de prendido.
- Page 12 All manuals and user guides at all-guides.com SERvICIO TÉCNICO Favor de llamar al 1-800-858-8501 (sólo para hablar en inglés) para pedir ayuda antes de devolver el producto a la tienda. Si tiene algún problema, siga esta guía. Usted puede también visitar nuestro sitio Web: www.hzsupport. com.
- Page 13 All manuals and user guides at all-guides.com Exigences • La commande d’éclairage nécessite une alimentation de 120 V c.a. Commande d’éclairage • Pour utiliser la priorité manuelle, raccorder la com- mande à un interrupteur. • Certains codes de bâtiment locaux peuvent exi- à...
- Page 14 All manuals and user guides at all-guides.com INSTALLATION PRIORITÉ MANUELLE Le mode manuel ne fonctionne que Pour faciliter l’installation, choisir un appareil d’éclairage la nuit parce que la lumière du jour devant être remplacé et qui est déjà commandé par un remet le capteur en mode AUTO.
- Page 15 All manuals and user guides at all-guides.com Installation de L’ampoule Montage de la Commande D’Éclairage NOTE: Avant de remplacer une ampoule, couper l'ali- ❒ Insérer la vis de montage dans le trou du couvercle mentation et attendre que l'appareil refroidisse. de la boîte de jonction.
- Page 16 All manuals and user guides at all-guides.com ESSAIS ET RÉGLAGES NOTE : Lorsque le luminaire est installé à une hauteur supérieure à 8 pi (2,4 m), le fait de diriger le détecteur ❒ Mettre en circuit le disjoncteur et l’interrupteur vers le bas réduit la portée de la couverture.
- Page 17 All manuals and user guides at all-guides.com FICHE TECHNIQUE Modes d’éclairage . . . Normal, Doux/Soft, Clignote- ment/Flash Portée ... . 21 m avec amplification de Minuterie ..1, 5 ou 20 minutes portée hors circuit et de 30,5 m .
- Page 18 All manuals and user guides at all-guides.com SERvICE TECHNIQUE veuillez faire le 1 800 858-8501 (service en anglais seulement) pour obtenir de l’aide avant de retourner l’article au magasin. En cas de problème, suivez ce guide. Vous pouvez aussi visiter notre site Web à www.hzsupport.com. Si le problème persiste, composez* le 1 800 858-8501 (service en anglais seulement), entre 7 h 30 et 16 h 30, HNC, du lundi au vendredi.
- Page 19 All manuals and user guides at all-guides.com Notes / Notas ______ __________________ __________________ __________________ __________________ __________________ __________________ __________________ __________________ __________________ __________________ __________________ 598-1315-02...
- Page 20 All manuals and user guides at all-guides.com Purchase Information Información de la compra Renseignements d’achat Model #: _________________ Date of Purchase: _____________ Nº de modelo / N° de modèle Fecha de compra / Date d’achat Staple Purchase Receipt Here Engrape aquí el recibo de compra Agrafez le reçu d’achat ici PLEASE KEEP YOUR DATED SALES RECEIPT, IT IS REQUIRED FOR ALL WARRANTY REQUESTS.