Heath Zenith DualBrite PF-4192-BK Mode D'emploi page 3

Note: All wiring should be run in accordance
with the National Electrical Code through
conduit or another acceptable means.
Contact a qualified electrician if there is
any question as to the suitability of the
system.
CAUTION: DO NOT connect the RED
wire unless you want to control other
lights from the motion sensor.
Black
Green
or Bare
White
White
Black
Green
or Bare
598-1167-05
Get user manuals: See SafeManuals.com
WIRING
Fixture
One Motion Light
Light
Fixture
Two Motion Lights
❒ Twist the junction box wires and the
fixture wires together as shown below.
Secure with wire connectors. If you have
a metal junction box, you may not need
the green "pigtail". If you are unsure about
the grounding method, consult your local
building code.
Connect the fixture wires to the wires in the
junction box. Twist the wires together and
secure with wire connectors.
Recommended Grounding Method
Light
Use a green ground "pigtail" (not provided) and
twist one end together with the bare fixture wire
and the box ground wire. Secure with a wire
connector. Secure the other end of the "pigtail"
with the GND screw on the mounting plate.
Light
Fixture
Black to black
3
White to white