Publicité
Les langues disponibles
Les langues disponibles
Installing the Ground Lug and Bracket
Assembly
Install the ground (GND) lug and bracket assembly, with a ground wire
attached, before you install the S4048T-ON switch in a rack.
Dell Networking supplies a kit with the following:
•
One two-hole UL-certified GND lug
•
L-bracket
•
Two flat head screws (to attach lug to bracket)
•
Two pan head screws (to attach assembly to chassis)
You must supply:
•
A wire that complies with your local electrical codes in size and color
(typically the wire is 14 AWG, colored green or green with a yellow stripe).
•
An anti-oxidant compound (Dell Networking recommends NOALOX 4 or
equivalent).
•
A crimping tool.
•
A thread-locker compound (Dell Networking recommends Threadlocker
Blue 242 or equivalent).
1.
Attach the end of the ground wire to the GND lug:
a. Coat the bare end of the wire with an anti-oxidant compound.
b. Insert the end of the wire into the lug.
c. Crimp the lug end to secure the connection of wire to lug.
7
Publicité
