IARP EIS 30 Instructions D'emploi Et D'entretien page 7

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

INSTALLATION
Take out packaging and clean all the cabinet using warm water
together with 5% of neutral soap then dry it with a soft cloth; for the
glass parts only use specific products, avoiding the use of water
which can leave on the glasses limestone residues.
Keep a distance from the wall of 10 cm at least. Please settle the
adjustable feet 10 mm lower than the level face of small rollers.
Cabinet must be installed on a perfectly even surface,
far away from any heat source (radiators, stoves,
etc)including sun rays.
Good running of the cabinet can be compromised
in cases where the airflow is disturbed (wind,
ventilators, air conditioning outlets, etc).
Smooth running of the cabinet is assisted when
sufficient air is permitted to flow through the
bottom of the unit; it is very
grills at the base are kept uncovered.
Do not expose the cabinet to rain. Install and
position the unit in such a way so as to allow easy
access to the power socket.
Never use electrical equipment in the refrigerated compartment
Never place containers of liquid on or immediately above the ticket counter; should the content spill
out, it would damage the counter.
THE REFRIGERATOR IS NOT SUITABLE FOR WORKING IN DANGEROUS ENVIRONMENT
WITH RISK OF FIRE, EXPLOSIONS OR RADIATIONS.
Operation is regular with ambient temperature indicated on technical data plate.
INFORMATIONS ABOUT USE
important that the
On models STAR,VFP insert between glass door and
motor space the wood part to avoid door frame foldings
during transport; on models EIS, after installation, cut off
with a blade the dowel door support from the base of the
cabinet, then pull it out and reinsert it upside-down in the
hole. Reinsert it when the cabinet is removed.
- 7 -
10 cm.
150°
WARNING!!
to prevent damaging
the mechanism do not
exceed the maximum
angle of door opening
ENGLISH

Publicité

Table des Matières
loading

Table des Matières