Publicité
Les langues disponibles
Les langues disponibles
7-3. Setting the SCSI-ID Numbers, etc.
s Procedure for setting the SCSI-ID No. and other jumper settings.
Please refer to the specified section(s) of the corresponding drive instruction manual.
s Make sure to turn the power OFF before starting the procedure. If the procedure is carried out with the power ON, it will
cause malfunction.
s The new ID Nos. will become effective from the the moment the power is turned on.
s The new SCSI ID Nos. should not conflict with the ID Nos. of other SCSI equipment on the same SCSI bus.
s The SCSI ID numbers should be in the range from 0 to 7. Numbers from 8 to 15 cannot be used.
7-4. Connecting the cables
s For the positions of the connectors for the cables from
the optional drives, please refer to the relevant instruc-
tion manuals for the drives.
1.
Connect the control cable (14P).
• Connect the control cable having the same number
as the drive bay number.
2.
Connect the power cable (14P).
(The figure shows the case of the MC-R434U.)
3.
Connect the two LVD power cables (6P) to the SE-LVD
conversion board.
• Both cables have identical connector types, so that
either cable can be connected to either connector on
the SE-LVD conversion board.
4.
Connect the internal SCSI (SE) cable (50P) to the SE-
LVD conversion board.
• The other end of the internal SCSI (SE) cable is con-
nected to the library SCSI board in the library.
5.
Connect the internal SCSI (LVD) cable (68P) to the
drives.
• The other end of the internal SCSI (LVD) cable is con-
nected to the SE-LVD conversion board.
Internal SCSI cable (approx. 1.0 m)
To SE-LVD conversion board
Internal SCSI (LVD) cable
Terminator
Drive 6
Drive 5
Drive 4
Drive 3
Drive 2
Drive 1
Terminator
Library SCSI board
Internal SCSI (SE)
cable
1.
W
N
2.
68P
<MC-R433 rear panel>
Library
< SE-LVD conversion board >
Internal SCSI (SE) cable
4.
50P
6P
3.
6P
68P
5.
Internal SCSI (LVD) cable
To each drive
Drive Units
Control cable
14P
DIP switch
4P
Power cable
LVD power
cable
E23
Publicité
