Publicité
Les langues disponibles
Les langues disponibles
3-4. Removing the optional carrier transport lock screw
When the MC-CF10U is installed, its special transport lock should be removed in addition to its being unlocked as
detailed in "3-2. Opening the transport lock" on page E11. Use the following procedure when unlocking the optional
carrier transport lock.
1.
Remove the transpor t lock
screw (for optional carrier).
2.
Insert the removed screw into the desigated storage hole for
the transport lock screw.
• If the system is transported with the MC-CF10U Optional Carrier installed, refer to "3-2. Opening the transport lock",
execute the packing mode and clamp the above-mentioned transport lock screw.
3-5. Installing drives and settings SCSI-ID No., etc.
1.
Installing drives
Install the drives ( a See "7. DRIVE UNITS" on page E22).
2.
Initial setting of SCSI-ID No., etc.
The default setting of the SCSI-ID No. of the MC-8200LU/8600LU is "0".
Set the SCSI-ID No. according to your system.
• To change the SCSI-ID No. of the MC-8200LU/8600LU a Read "8. SETTING THE SCSI-ID NUMBERS OF THE MAIN
UNIT" on page E26.
• To set the SCSI-ID Nos. and termination of drives a Read the instruction manuals of the installed drives.
• As the MC-8200LU/8600LU should be turned on to allow its SCSI-ID No. to be set, read "3-6. Connecting the power
cord and cables" on page E14 and connect the power cord before proceeding.
Setup
E13
Publicité
