Mitsubishi Electric Mr.Slim SEZ-M71DAL Manuel D'installation page 7

8
[Fig. 8-10]
Ⓑ
Ⓔ
Ⓒ
[Fig. 8-11]
Ceiling cassette type, Ceiling concealed type
[Fig. 8-12]
[Fig. 8-13]
[Fig. 8-14]
①
②
[Fig. 8-15]
When using the switch box
Wall
Ⓐ
Ⓐ 150 mm (5 - 15/16 inch)
Ⓑ Remote controller wire (Accessory)
Ⓒ Wiring pipe
Ⓓ Locknut
Ⓐ
Ⓕ
Ⓖ
Ⓓ
Ⓗ
Ⓐ
Indoor unit
Ⓒ
Ⓑ
Ⓐ
Ⓒ
Ⓐ
Insert the minus screwdriver toward the
arrow pointed and wrench it to remove
the cover.
A flat screwdriver whose width of blade
is between 4 and 7 mm (5/32 - 9/32 inch)
must be used.
①
Ⓑ
Ⓒ
Ⓓ
Ⓔ
Ⓕ
Ⓖ
Ⓔ Bushing
Ⓕ Switch box
Ⓖ Seal around here with putty
8.3
Ⓐ Signal receiving unit external
Ⓑ Center of Switch box
Ⓒ Switch box
Ⓓ Installation pitch
Ⓔ 6.5 mm (1/4 inch)
Ⓕ 70 mm (2 - 3/4 inch)
Ⓖ 83.5 ± 0.4 mm (3 - 9/32 inch)
Ⓗ Protrusion (pillar, etc)
Ⓐ Remote controller wire
Ⓑ Hole (drill a hole on the ceiling to pass the remote controller wire.)
Ⓑ
Ⓒ Signal Receiving Unit
Ⓐ Fix tightly with tape.
Ⓑ Remote controller wire
Ⓒ Order wire
① Hang the cover to the upper hooks (2 places).
Ⓐ
② Mount the cover to the lower case
Ⓐ Cross-section of upper hooks
When installing directly on the wall
Ⓗ
Ⓗ Seal around here with putty
Ⓘ Remote controller wire
Ⓙ Seal around here with putty
Ⓘ
Ⓙ
7