Publicité
Les langues disponibles
Les langues disponibles
• Place the outlet adapter (1x) over the hood exhaust
and secure with 2x M4x12mm self-tapping screws
• Use duct tape to seal the connection. Check to make
sure the damper moves freely.
Hang hood on mounting bracket
Lift the hood and hold it close to the mounting bracket. Line up mounting
holes in "B" position.
Make sure the screw head on the bracket is engaging into the keyhole
slots on the back of the hood.
Slide down the hood to make it hang correctly on the bracket.
Tighten the screws in the "B" position.
Make sure the hood is leveled and centered. 8 holes in the "C" position
must line up with bracket holes properly.
Install 8xM4x8mm self-tapping screws through the back of the hood in
the "C" positions and tighten to the mounting bracket.
INSTALL HOOD TO SOFFIT OR BENEATH CABINETS
SKIP THIS STEP IF USING WALL MOUNTING METHOD
When necessary, the hood may be installed so that it is
supported by the soffit
• The soffit should be constructed with 2x4's
• Determine the installation location on the wall.
• Continue the centerline forward on the bottom of the
cabinet or soffit
• The opening above the hood should allow for the 10"
round duct and clearance to slide the hood back against
the wall.
• The 2x4 studs must be located as shown in the chart, Dim. A. to accept mounting screws
"A" centerline to
stud and keyhole
slots
"F" hood width at
the top
11
Require
10-1/2"
minimum
ductwork and hood installation.
Front of hood
opening
for
Top view
Publicité
