Publicité
Les langues disponibles
Les langues disponibles
Remove packaging
Place mounting bracket against the wall, line up with the centerline and rest on top of backsplash.
Use M3.5x30mm self-tapping screws to fix bracket to the wall through the holes at top, middle, bottom
of mounting bracket (4x at top, 4x in middle, 4x at bottom)
NOTE: Make sure screws are installed in vertical studs as much as possible
INSTALL WARMING SHELF TO THE HOOD
• Install 2x M4x8mm self-tapping screws into "D" holes at the
bottom of the hood flange, leaving a gap of 1/8".
• Remove shelf packaging and protective film (if any).
• Attach the warming shelf to the bottom of hood by inserting
the top of the self-tapping screws into the keyhole slots on
the top of the shelf. Slide the shelf towards the left to lock it
into place.
• Tighten 2x M4x10mm screws & washers through the
bottom of the shelf into the hood flange in the "E"
position
INSTALL HOOD ONTO WALL
SKIP THIS STEP IF INSTALLING BENEATH A SOFFIT OR CABINET
Install outlet adapter onto top of hood
IMPORTANT: Check that the damper moves freely
Centerline
Bracket mounting holes
Bracket mounting holes
Bracket mounting holes
Top of back splash
10
Publicité
