Dometic DSP Serie Instructions De Montage Et De Service page 18

Connecting the inverter
9.4 Connecting the remote control (accessory)
A
NOTICE!
Only plug in the connection to the remote control in the remote port.
The device can be damaged by connecting it incorrectly.
➤ Connect the remote control as shown (fig. 9).
9.5 Connecting external switch to turn device on and off
I
NOTE
Use cables with a cable cross section of 0.25 – 0.75 mm².
You can use the following as an external switch:
• External switch, voltage supply from the inverter: fig. 0 A
• Control unit with relay or transistor circuit (TR): fig. 0 B
• External switch with voltage supply from the battery (BAT) of the vehicle:
fig. 0 C
• External switch with its own voltage supply (DC POWER) e.g. from the ignition:
fig. 0 D
➤ Set the main switch (fig. 2 1) to "OFF".
➤ Make sure that the connection for the remote control (fig. 2 12) is not assigned.
➤ Set the main switch (fig. 2 1) to "REMO.".
➤ Connect the external on/off switch with the connection cable to the terminal
(fig. 2 13).
16
SinePower
EN