Publicité
Les langues disponibles
Les langues disponibles
Light Bulbs
(CRSA1, CRSH1 and NRSL1 Series only)
The CRSA1, CRSH1 and NRSL1 Series range hoods require two shielded Halogen Bulbs
(120 V, 50 W max., MR16 or PAR16 with GU10 base) (included only with CRSH1 and
NRSL1 Series range hoods).
NOTE: Before using lamps, remove shipping tape on them (if present).
1 ] Align the bulb leads with the small indentations located on the border of the lamp location on
2 ] Gently push upwards and turn clockwise until secure.
NOTE: The Suction Cup Tool (included with hood) can be used to install and remove light bulbs.
Install the Filter(s)
Ducted Installation Only:
Re-install grease filter(s) removed in step 2 on page 11, under "Prepare the Hood" .
Non-ducted Installation Only:
According to your range hood model, purchase one or two non-ducted filters from your local
distributor or retailer (see product specification label for filter type). Attach the non-ducted filter(s)
22
following instructions packed with the non-ducted filter.
Do not touch lamps during or soon after operation. Burns may occur. In order to prevent
the risk of personal injury, only install shielded halogen lamps. Also, never install a cool
beam, a dichroic lamp, a lamp not suitable for use in recessed luminaires or identified for
use in enclosed fixtures.
BULB LEADS
hood (see inset above), then install the bulbs by placing the bulb leads into their grooves in
the socket.
Press suction cup tool on bulb and rotate counterclockwise to remove bulb or clockwise to
install bulb.
Most GU10 LED replacement bulbs commonly found in the market are not designed
for use in a cooking environment and might not perform as advertised. Their usage
with this product is not recommended.
!
WARNING
BULB LEAD
GROOVES
(IN SOCKET)
!
CAUTION
SUCTION
CUP TOOL
Publicité
