Metrohm 758 KFD Titrino Mode D'emploi page 112

3.2 Remote control commands
108
3.2.2.48. UserMeth.FreeMem
Memory space, available for user methods or silo lines. $Q sends the number
of free bytes, e.g. "4928".
3.2.2.49. UserMeth.Recall
UserMeth.Recall.Name
UserMeth.Store
UserMeth.Store.Name
UserMeth.Delete
UserMeth.Delete.Name
UserMeth.DelAll
Management of the internal method memory: Load, store and delete methods.
An action is performed if "$G" is sent to the corresponding node just after en-
tering the name.
Do not use blank characters before and after method name!
.DelAll: Deletes all methods in the user memory.
3.2.2.50. UserMeth.List.1.Name
UserMeth.List.1.Mode
UserMeth.List.1.Quantity
UserMeth.List.1.DosUnit
UserMeth.List.1.Bytes
UserMeth.List.1.Checksum
for each method
List of the methods in the user method memory with the following
characteristics:
.Name: Name of the method
.Mode: Mode
.Quantity: Measured quantity
.DosUnit: Buret of the method
.Bytes: Number of bytes of the user memory used by the method
.Checksum: Checksum of the method, see 3.2.2.104.
3.2.2.51. MemoryCard.Recall
MemoryCard.Recall.Name
MemoryCard.Store
MemoryCard.Store.Name
MemoryCard.Delete
MemoryCard.Delete.Name
Administration of the method memory of the current directory of the memory
card: load, store and delete methods. The action is carried out, if "$G" is
transmitted to the corresponding node.
Do not use blank characters before and after method name!
read only
$G
up to 8 ASCII characters
$G
up to 8 ASCII characters
$G
up to 8 ASCII characters
$G
read only
read only
read only
read only
read only
read only
$G
up to 8 ASCII characters
$G
up to 8 ASCII characters
$G
up to 8 ASCII characters
758 KFD Titrino