SOLAC PV2114 Mode D'emploi page 6

ENGLISH
DESCRIPTION
A Spray button
B Steam blast button
C Steam flow control
D Auto-cleaning button
E Temperature regulator
F Pilot light
G Filling spout
H Spray nozzle
I Soleplate
Read these instructions carefully before
•
switching on the appliance and keep them for
future reference. Failure to follow and observe
these instructions may result in an accident.
USE AND CARE:
Fully unroll the appliance's power cable before
•
each use.
Do not use the appliance if the accessories at-
•
tached to it are defective. Replace them imme-
diately. Do not use the appliance on any part of
the body of a person or animal.
Do not use the appliance on pets or animals.
•
Do not use the appliance to dry garments of
•
any kind.
Turning the thermostat control to the minimum
•
(MIN) setting does not guarantee that the iron
is switched off completely.
INSTRUCTIONS FOR USE
BEFORE USE:
Peel off appliance's protective film.
•
Make sure that all the product's packaging has
•
been removed.
Some parts of the appliance have been lightly
•
greased, consequently, the appliance may give
off a light smoke the first time it is used. After a
short time, this smoke will disappear.
Prepare the appliance according to the func-
•
tion you wish to use:
FILLING WITH WATER:
It is essential to have filled the tank with water
•
to be able to work with steam.
Open the lid on the filling spout.
•
Fill the tank, taking care to respect the MAX
•
level (Fig. 1).
Close the filling spout lid.
•
USE:
Unroll the cable completely before plugging it
•
in.
Connect the appliance to the mains.
•
Turn the thermostat control to the desired tem-
•
perature position.
Do not use temperatures higher than those in-
•
dicated on the garments to be ironed.
● Temperature for synthetic fibres
(Polyester, Nylon...).
●● Temperature for silk, wool.
●●● Temperature for cotton.
Max Temperature for linen.
If garment has various kinds of fibres, select
•
the temperature for the fibre that requires the
lowest temperature. (For example, select the
temperature for polyester for a fabric made out
of 60% polyester and 40% cotton).
Wait until the pilot light (F) has gone out, indi-
•
cating that the appliance has reached an ade-
quate temperature.
During use the pilot light (F) will automatically
•
flash on and off, indicating that the heating el-
ements are operating in order to maintain the
desired temperature.
DRY IRONING:
The appliance has a steam flow regulator
•
which, when set to 1, allows dry ironing (with-
out steam).
STEAM IRONING:
It is possible to iron with steam whenever the
•
tank has water and the adequate temperature
is selected.
STEAM FLOW CONTROL:
The appliance has a (C) control knob for ad-
•
justing the steam flow (Fig 2, Fig 3).
SPRAY:
The spray can be used in both steam and dry
•
ironing.
Press the spray button ( A ) to use this oper-
•
ation.
The spray button has to be pressed repeatedly
•
to release the first spray.
STEAM BLAST:
This function provides extra steam for remov-
•
ing creases.
EN