Error
A solid
RED LED
for each bank is lit
A blinking
RED LED with
solid 25% YELLOW LED
A blinking
RED LED with
solid 50% YELLOW LED
A blinking
RED LED with
solid 75% YELLOW LED
A blinking
RED LED with
solid 25% and 50% YELLOW LEDs
A blinking
RED LED with
solid 25% and 75% YELLOW LEDs
A blinking
RED LED with
solid 25%, 50% and 75%
YELLOW LEDs
Blinking GREEN and
25% YELLOW LEDs
Model
Part No.
MK 230PCL
1832302
MK 345PCL /
1833452
MK 345PCLS
MK 460PCL /
1834602
12 / 24 / 36 / 48
MK 460PCLS
©2021 Johnson Outdoors Marine Electronics, Inc.
TROUBLESHOOTING
•
No battery is connected to an output cord. This may also indicate a blown fuse in the fuse holder.
•
The battery is connected reverse polarity.
•
A short circuit.
•
The battery voltage is below 0.5 volts. The bank will not charge a battery in this condition. If in
Lithium Mode, the charger will attempt to wake the battery from Standby Mode.
•
The battery voltage is above 16 volts. The bank will not charge a battery in this condition.
•
The battery voltage did not rise above 10.5V. The battery may be damaged and will not continue
to be charged.
•
Charging in Bulk Mode exceeded the time limit.
•
There is a damaged temperature sensor. The bank will not operate if this occurs.
•
A fault within the charger. The bank will not operate if this occurs.
•
The battery charger overheated and shut down. Unplug charger and allow to cool. After powering
up, the charger will operate as normal.
•
The charger is set to Lithium Mode and the charger exceeded the number of attempts allowed to
wake the battery from Standby Mode.
•
The battery is less than 10.5 volts and the charger is in low output power safety mode. Full
charging will begin once the battery reaches 10.5 volts. If the battery voltage does not rise above
10.5 volts, then make sure all loads are disconnected from the battery and try again.
Specifications Input Voltage: 95-135VAC, 60Hz
Output
System Volts
Banks
per Bank
(amps)
12 / 24
2
15
12 / 24 / 36
3
15
4
15
ERROR CONDITIONS
Solution
Total
Input
Output
Cable
(amps)
30
14AWG - 6'
45
14AWG - 6'
60
14AWG - 6'
Size
Output
Weight
L x W x H
Cable
(lbs)
(inches)
7-5/8 x 9-1/4
12AWG - 6'
x 3
12AWG - 6'
11 x 9-1/4 x 3
13.7
14-3/8 x 9-1/4
12AWG - 6'
x 3
Input Current
(120VAC,
60Hz)
9.6
7A
10.5A
18
14A
minnkotamotors.com | 21