Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
INSTALLING THE MK-EC BATTERY CHARGER EXTENSION CABLE
The Minn Kota Battery Charger Extension Cables are ideal for
extending charger output cables that do not reach the bow,
center or transom battery compartments. Featuring easy installation
with waterproof adhesive heat shrink for use in saltwater
environments. Each conductor is fused for protection against
accidental short circuits.
INSTALLATION PARTS LIST
Item /
Part #
Description
Assembly
✖
2
15FT EXTENSION CABLE
4
✖
WIRE SPLICE
✖
6
ADHESIVE HEAT SHRINK
✖
This part is included in an assembly and cannot be ordered individually.
TOOLS AND RESOURCES REQUIRED
• Wire Cutters
• Wire Strippers
INSTALLATION
1
a.
Remove AC power from your charger and disconnect
the charger from ALL batteries.
b.
Open the door or hatch of the compartment and allow
it to air out for 15 minutes. This allows any gases that
have accumulated in the compartment to escape.
c.
Find the Charger Output Cable you would like to
extend and use the wire cutters to cut the red or
white (positive) and black (negative) wires before
the Fuse Holders.
14 | minnkotamotors.com
Qty.
1
2
2
• Crimpers
• Heat Gun
NOTICE:
The MK-EC Battery Charger Extension Cable
(#1820089) is an optional kit that is NOT included with
the charger.
1
Fuse Holder
Fuse Holder
Cut Here
Cut Here
Fuse Holder
Fuse Holder
©2021 Johnson Outdoors Marine Electronics, Inc.
3
2
Charger Output Cables
Charger Output Cables
Publicité
