Husqvarna TS 148 Manuel D'utilisation page 16

2. Connect one end of the BLACK cable to the
NEGATIVE (-) terminal (D) of a fully charged
battery.
3. Connect the other end of the BLACK cable (A)
to good chassis ground, away from the fuel tank
and battery.
4. Remove the BLACK cable from the chassis when
the weak battery is fully charged.
5. Remove the BLACK cable from the fully charged
battery.
6. Remove the RED cable from the two batteries.
To remove the jumper cables
Note:
Remove the jumper cables in the opposite
sequence to how you connect them.
1. Remove the BLACK cable from the chassis.
2. Remove the BLACK cable from the fully charged
battery.
3. Remove the RED cable from the 2 batteries.
To set the cutting deck in transport
position or mow position
The cutting deck must be in transport position during
transportation.
• To set the product in transport position, pull the
cutting height lever in the direction of the seat
and put it in the highest cutting height position.
• To set the product in mow position, set the
correct cutting height. Refer to
height on page 16 .
To set the cutting height
• Pull the lift lever in the direction of the seat and
put it in 1 of the notches for the correct cutting
height.
To move forward and rearward
The direction and speed of movement is controlled
by the motion control lever.
1. Start the engine.
2. Disengage the parking brake. Refer to
engage and disengage the parking brake on
page 16 .
16
To set the cutting
To
3. To start movement, slowly move the motion
control lever (A) forward (B) or rearward (C).
C
D
4. Move the motion control lever more forward or
rearward to increase the speed.
5. Put the motion control lever in the neutral
position (D) when you park and stop the product.
To engage and disengage the
parking brake
1. To engage the parking brake, push down the
brake pedal (A) fully to the lowest position.
A
2. With the brake pedal pushed down, pull up the
parking brake lever (B).
3. Release the brake pedal.
4. Release the parking brake lever.
Note:
Make sure that the parking brake holds
the product safely.
5. To release the parking brake, push down the
brake pedal.
To stop the product
WARNING:
product, engage the parking brake and
remove the ignition key before you go
away from the product.
A
B
B
Always stop the
1947 - 005 - 19.10.2022