Husqvarna TS 148 Manuel D'utilisation page 13

To install the engine cover piece
1. Align the front tab on the engine cover piece with
the cut-out in the engine cover.
2. Align the rear tabs on the engine cover piece
with the cut-outs in the engine cover.
3. Push down the engine cover piece on the engine
cover.
To adjust the seat
1. Sit in the seat.
2. Lift up the seat adjustment lever (A).
3. Move the seat until it is in a position where you
can push the brake and clutch pedals down.
1947 - 005 - 19.10.2022
4. Release the seat adjustment lever (A) to lock the
To connect the battery
Note:
on the battery label, charge the battery. Charge the
battery for a minimum of 1 hour at 6–10 A.
1. Find the battery location below the seat or the
2. Lift the seat pan or the engine cover to the raised
3. Remove the 2 terminal caps (A) and discard
4. Connect the red battery cable to the positive (+)
A
5. Connect the black cable to the negative (-)
6. Apply petroleum jelly on the battery cables to
7. Lower the seat pan or the engine cover.
To move the product off the skid
1. Lift the cutting deck to its highest position. Use
seat in position.
WARNING:
and burn injuries. Do not use metal
wristbands or other metal accessories.
Metal items that touch the battery
terminals can cause burn injuries,
electrical shock, and short circuit of the
battery.
If it is after the year and month that is written
engine cover.
position.
them.
terminal and tighten the bolt and nut as shown.
Move the terminal cover on the terminal.
WARNING:
red battery cable must be connected
to the positive terminal before the
black battery cable is connected
to the negative terminal. This is
to prevent sparks and accidental
grounding.
terminal and tighten the bolt and nut fully.
prevent corrosion.
the lift lever.
Risk of electrical shock
A
Risk of sparks. The
13