Publicité
Les langues disponibles
Les langues disponibles
3
Installation
3.1. Appropriate
Installation Location
Contact an Authorized Service for the
installation of the product. In order to
prepare the product for use, refer the
information in the user manual and
ensure that electrical installation and
water installation are appropriate. If not,
call a qualified electrician and technician
to have any necessary arrangements
carried out.
WARNING: Manufacturer shall
not be held liable for damages
B
that may arise from procedures
carried out by unauthorized
persons.
WARNING: Product must
not be plugged in during
B
installation. Otherwise, there
is the risk of death or serious
injury!
WARNING:
If the door clearance of the
room where the product shall
be place is so tight to prevent
A
passing of the product, remove
the door of the room and pass
the product through the door
by turning it to its side; if this
does not work, contact the
authorized service.
•
Place the product on an even floor
surface to prevent jolts.
•
Install the product at least 30 cm
away from heat sources such as hobs,
heater cores and stoves and at least 5
cm away from electrical ovens.
•
Product must not be subjected to
direct sun light and kept in humid
places.
Refrigerator/User Manual
•
Appropriate air ventilation must be
provided around your product in order
to achieve an efficient operation. If the
product is to be placed in a recess in
the wall, pay attention to leave at least
5 cm distance with the ceiling and side
walls.
• Your product requires adequate air
circulation to function efficiently. If
the product will be placed in an alcove,
remember to leave at least 5 cm
clearance between the product and the
ceiling, rear wall and the side walls.
• If the product will be placed in an
alcove, remember to leave at least 5
cm clearance between the product
and the ceiling, rear wall and the side
walls. Check if the rear wall clearance
protection component is present at its
location (if provided with the product).
If the component is not available, or if
it is lost or fallen, position the product
so that at least 5 cm clearance shall be
left between the rear surface of the
product and the wall of the room. The
clearance at the rear is important for
efficient operation of the product.
9 / 23 EN
Publicité
