Publicité
Les langues disponibles
Les langues disponibles
Once the correct position for anchorages has been determined and the anchorages have been installed on the structure, attach the device
anchorage, unwind the secondary cable
the anchorage. Finally, connect the secondary cable
Ensure that the secondary cable
1
of the device
can be adjusted using the stabilisation anchorage
Stabilization anchorage:
Stabilise the unit using an adjustable safety strap, a rope or another device attached to the stabilisation point
goal of orientating the unit to adjust its angle and to ensure that the secondary
Strengths:
Minimum strength of anchorage devices EN 795: 19 kN
Minimum strength of the receiving structure: X and Y direction = 13.5 kN
Before first use, we recommend that the installation be visually inspected by a suitable person who can carry out the "acceptance" of this
installation. This person must check, among other things: suitability of the structural anchorages and the receiving structure; the installation
plan relative to the job to be performed; cross-compatibility between system components (anchorage, connector, T-LINE).
USE:
For T-LINE use, the secondary cable connector
attachment point of their body gripping device (Figure 5).
The T-LINE system is ready to use!
The user must remain between the T-LINE and the pulley when moving.
WARNING: Two users cannot use the T-LINE system at the same time.
6
together with the redirection pulley
6
to the connection ring
5
6
and the main cable
are positioned in the centre of the cable outlet guide (Photo 3); if this is not the case, the position
Photo 3
7
is connected to the connection ring
Photo 4
2
as far as the second anchor and then attach the redirection pulley
8
via the secondary cable connector
11
.
6
5
and main
cables are centred in their cable outlet guides.
8
(Photo 4). The user then connects the main connector
14
7
(included).
11
and connected to the structure, with the
Photo 5
1
to the first
2
to
9
to the
Publicité
