Télécharger Imprimer la page

Black & Decker G650 Serie Mode D'emploi page 8

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH
Labels on tool
The label on your tool may include the
following symbols:
Hz .......
Read
Instructions
W ........
Manual
min .....
Use Eye
Protection
.....
Use Ear
Protection
.....
V ........
Volts
n .......
A ........
Amperes
List of Content
1 Angle Grinder
1 Side Handle
1 Wrench
Position of date barcode
The Date Code, which also includes the year
of manufacture, is printed into the housing.
Example:
2017 XX JN
Year of manufacturing
Electrical safety
Your tool is double insulated;
therefore no earth wire is required.
Always check that the main voltage
corresponds to the voltage on the
rating plate.
Warning! If the power cord is
damaged, it must be replaced by
the manufacturer, authorized
BLACK+DECKER Service Center or
an equally qualified person in order
to avoid damage or injury. If the
power cord is replaced by an equally
qualified person, but not authorized
by BLACK+DECKER, the warranty
will not be valid.
FEATURES (Fig. A)
1. Slider switch
2. Cable
3. Guard
4. Body grip
5. Side handle (2 positions)
8
All manuals and user guides at all-guides.com
(Original instructions)
......
Hertz
Class II
Construction
Watts
....
Earthing
minutes
Terminal
Alternating
....
Safety Alert
Current
Symbol
Direct
.../min..
Revolutions
Current
or Recipro-
cation per
minute
Rated
speed
6. Spindle lock button
OPERATION
Operatingyour angle grinder (Fig. A)
To switch on, push the slider switch forward
(1). To switch o , press the rear of the slider
switch.
Fitting the discs (Fig. B and C)
Proceed as follows:
• Disconnect the plug from the electricity
supply.
• Ensure the guard is fitted. Place the inner
flange (7) on the spindle. Ensure it is
located on the two flats.
• Place the abrasive disc on the spindle and
inner flange (8). Ensure it is correctly
located.
• Fit the threaded outer flange (9), making
sure it is facing in the correct direction for
the type of disc fitted. For grinding discs,
the flange (9) is fitted with the raised
portion facing towards the disc. For
cutting discs, the flange (9) is fitted with
the inner portion facing away from the
disc.
• Hold the spanner on the flats of the
spindle to prevent rotation of the disc
and tighten the outer flange with the
spanner provided.
• Press in the spindle lock button and
rotate the spindle until it locks (Fig. C).
Keeping the lock button pressed in,
tighten the outer flange with the spanner
provided.
Fitting sanding discs (Fig. D)
• Use a sanding disc with the backing pad
for sanding with your angle grinder.
• Disconnect the plug from the electricity
supply.
• Remove the guard.
• Place the flange on the spindle. Place the
backing pad on the spindle and inner
flange, ensuring it is correctly located.
• Mount the fibre backed abrasive disc on
the backing pad.

Publicité

loading

Ce manuel est également adapté pour:

G650-b5/zaG650-b9