Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Installation Procedure
I n s t a l l a t i o n P r o c e d u r e
P r e p a r e I n s t a l l a t i o n S p a c e
Vario appliances according to the installation diagram.
The angle of of the cut surface to the countertop must
be 90°.
After creating cut-out, remove shavings. Seal cut
surfaces in a heat-resistant manner.
Some solid surface countertops require special
installations. For example, heat reflective tape and
rounded corners may be necessary. Contact the
countertop manufacturer for instructions specific to your
countertop.
Observe minimum distance between appliance underside
and furniture parts of
When installing multiple Vario appliances: Take into account
space requirement for VV 200 010/020 connection strip
between the appliances. Appliances can also be installed
in individual cut-outs, bearing in mind a minimum
distance between the appliances of 1
Install Appliance
9
1.
2.
P repare Installation Space
C reate the cut-out in the countertop for one or several
3
/
" (10 mm).
8
WARNING
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the OFF
position.
Secure the appliance cover VD 200 020 (available
separately as special accessory) before fitting on the
appliance.
If the appliance is not being covered, seal the
openings on the back of the appliance using the cover
caps supplied.
Installation Procedure
9
/
" (40 mm).
16
en-us
7
Publicité
