Publicité
Les langues disponibles
Les langues disponibles
en-us
Before you begin
Before you begin
T ools and parts needed
B e f o r e y o u b e g i n
Phillips Head Screwdriver
▯
Pencil
▯
Drill with ¼" (6 mm) bit
▯
Jigsaw
▯
▯
Tape Measure
Note: Additional materials may be necessary for
installation in solid surface countertops. Contact the
countertop manufacturer.
Parts included
Installation accessories
VD 200 020
Black appliance cover
VV 200 010
Stainless steel connection strip for
combining with other Vario 200
appliances
VV 200 020
Black connection strip for combining
with other Vario 200 appliances
Use the accessories only as indicated. The manufacturer
assumes no liability for incorrect usage of the
accessories.
6
All manuals and user guides at all-guides.com
Cabinet Requirements
The distance from the top of the cooktop to the bottom of
cabinets above can be reduced to 24" when the bottom of
the wood or metal cabinet is protected by not less than
¼" (6.35 mm)-thick flame-retardant millboard covered
with not less than No. 28 MSG sheet metal, 0.015 inch
(0.4 mm) stainless steel, 0.024 inch (0.6 mm) aluminum
or copper.
Countertop Requirements
9
The countertop must be level and horizontal. The stability
of the countertop must be maintained after the cut-out
has been made.
WARNING
To reduce the risk of ignition of surrounding
combustible materials, install at least 1¼" (30 mm)
from both sidewalls and at least 2" (50 mm) from
the rear wall.
Publicité
