Publicité
Les langues disponibles
Les langues disponibles
2.6
rear exit
WARNING
!
•
Failure to create a seal to the fi rebox with the exhaust collar assembly will cause the appliance to function
improperly and can cause injury or property damage.
A.
Remove the safety barrier and glass front (see "safety barrier
& door removal / installation" section).
B.
Remove the contents from the fi rebox and set aside. You will
need the exhaust fl ue collar and the top baffl e (supplied).
C.
To ease assembly, remove the four hex head screws securing
the defl ector from inside the top front of the fi rebox (Fig. 1).
D.
Place the gasket (provided) over the 5" (127mm) fl ue collar assembly and
bend along perforation.
E.
From inside the fi rebox, insert the 5" (127mm) fl ue collar through the back of
the fi rebox. Install the rear exit shield onto the 5" (127mm) fl ue collar (see "rear
exit shield (for rear vent only)" section).
F.
Secure the fl ue collar assembly, gasket and rear exit shield using the four hex
head 3/8" thread cutting screws (Fig. 2).
note:
Do not overtighten. The gasket needs only to be snug against the fi rebox.
G.
Rest the front edge of the top baffl e in
the four slots on the defl ector. Rest the
rear edge of the top baffl e (complete with
defl ector) on the tabs of the fl ue collar
assembly. Reattach the defl ector (complete
with top baffl e) using the four screws
removed in step C (Fig. 3). Install the log
set, glass door and safety barrier.
2.7
rear exit shield (for rear vent only)
A.
Loosen the two screws, that secure the
exhaust plate, and slide the baffl e in place by sliding
its slotted openings behind the screwheads, tighten
the two previously loosened screws. Refer to the
illustration.
B.
Reinstall the door and safety barrier
assembly on the appliance (see "safety barrier &
door removal / installation" section).
note:
This shield is used to block the view through the venting to the outdoors.
venting requirements
DEFLECTOR
É
W415-1794 / I / 03.23.22
EN
Fig. 1
Fig. 2
Deflector
Top
baffle
Flue collar
assembly
Fig. 3
19
Publicité
