Publicité
Les langues disponibles
Les langues disponibles
W 550
Problem
Atomisation too
coarse
Spray jet
pulsates
Coating
material causes
"paint tears"
Too much fog of
coating material
(Overspray)
Paint in the
ventilating hose
18. Technical Data
Max. viscosity
Power source
Power consumption
Atomizing output:
Double insulation
Sound pressure level*
Sound pressure output*
Oscillation level**
Weight
* Measured in accordance with EN 50144-2-7:2000
** Measured in accordance with EN 60745-1
Cause
•
Viscosity of coating material too
high
•
Material volume too large
Material volume adjusting screw
turned too far to the right (+)
•
Nozzle contaminated
•
Air filter heavily soiled
•
Too little pressure build-up in
container
•
Coating material in container
running out
•
Air filter heavily soiled
•
Nozzle seal is missing or worn
•
Too much coating material
applied.
•
Distance to the object too large
•
Too much coating material
applied
•
Diaphragm soiled
•
Diaphragm defective
Technical Data
90 DIN-s
230 V
, 50 Hz
~
280 W
65 W
79 dB (A); Uncertainty K = 4 dB
92 dB (A); Uncertainty K = 4 dB
< 2.5 m/s²; Uncertainty K = 1.5 m/s
1,3 kg
Remedy
Thin
➞
Turn material volume
➞
adjusting screw to the
left (-)
Clean
➞
Change
➞
Tighten container
➞
Refill
➞
Change
➞
Insert an intact nozzle seal
➞
Turn material volume
➞
adjusting screw to the
left (-)
Reduce distance
➞
Turn material volume
➞
adjusting screw to the
left (-)
Clean the diaphragm
➞
Replace the diaphragm
➞
GB
25
Publicité
