Publicité
SPRAYER COMPONENTS & USE INFORMATION, Continued
INSTALLING THE PUMP HANDLE
The pump handle can be mounted on either side of the pump shaft (A). To
install the pump handle place the handle (C) over the shaft (A) aligning the
pump handle hole and shaft hole. Push the straight side of the cotter pin (B)
through the aligned hole as shown in figure 1 thru 3. There are holes in the
pump handle to allow for either left(fig.4) or right (fig.5) hand mounting.
Figure 1
Cotter Pin
Figure 4
Left Hand
STOWAWAY PUMP HANDLE
Pull
up
INSTALLING THE
SHOULDER STRAP
The top of the shoulder straps are
attached to the tank. Attach the
lower end of the straps by
clipping the strap hooks to the
metal frame between where the
frame exits the tank and curves
around.
NOTE: If your straps become
contaminated with dirt or
chemicals, wash with mild soap
and water and let dry overnight.
If this does not remove the
contamination, replace with new
straps.
Figure 2
Line up holes
Figure 5
Right Hand
Rotate
180º
3E
C
Figure 3
Slide pin through holes.
Pump Handle
Positioned For Use
(right hand shown)
Set
into
slot
WAND CLIP
The wand can
be attached to
the pump
handle using
the wand clip.
A
ASSE
B
Publicité
