Kicker KMTES8 Manuel D'utilisation page 4

Wiring: Attach the wiring from your amplifi er to the outer speaker terminals. Attach the included internal wiring
from the KMTES to your speaker, and then mount the speaker to the enclosure. If you are using a speaker or
grille equipped with LED wiring, run this wire through the LED wire port located underneath the outer speaker
terminals and then through the LED wire grommet.
LED wire grommet - Use
to form a seal around the LED
wiring and hole, preventing
moisture from entering the
enclosure.
4
LED wire port
LED wire plug - Use to seal
the LED wire hole located
below the speaker terminals
when LED-equipped
speakers are not in use.
LED wire port