Worx WG545E Traduction Des Instructions Initiales page 13

ASSEMBLY
ASSEMBLING THE BLOwER TUBE
(See Fig. A & Fig. B)
Before assembling the Blower Tube (4), be
sure the on/off switch (2) is in ''O'' Off position.
Fit the Blower Tube to the motor housing as
shown in Fig. A. Check the Blower Tube is
firmly secured.
wARNING! Do not attempt to
operate or disable the On/Off
Switch by any means other than the
normal assembly or removal of the tube.
NOTE: Before disassembling the Blower
Tube, be sure the on/off switch (2) is in ''O'' Off
position. Press the Release Button (3), so that
you can separate the tube (See Fig. B). Do not try
to separate the tubes by force or by using tools.
OPERATiOn
INTENDED USE:
The blower is intended for blow debris. It's not
intends for use indoors and animal grooming.
wARNING! The charger and battery
pack are specially designed to
work together so do not attempt to use
any other devices. Never insert or allow
metallic objects into your charger or
battery pack connections because of an
electrical failure and hazard will occur.
1. BEFORE USING yOUR CORDLESS
BLOwER
Your battery pack is UNCHARGED and you
must charge once before use.
The battery charger supplied is matched to the
Li-Ion battery installed in the machine. Do not
use another battery charger.
2. CHARGING yOUR BATTERy PACK
The Li-Ion battery is protected against deep
discharging. When the battery is empty,
the machine is switched off by means of a
protective circuit:
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool
down before recharging.
Cordless Li-ion Blower/Sweeper
3. TO REMOVE OR INSTALL BATTERy
PACK (See Fig. C)
Depress the battery release button (6) to
release battery pack from your tool. After
recharging, insert the battery pack into
tool's battery port. A simple push and slight
pressure will be sufficient.
4. STARTING/STOPPING (See Fig. D)
Starting
Move the On/Off switch (2) to the "I" On
position.
Stopping
Move the On/Off switch (2) to the "O" Off
position.
wARNING! The tool runs for a few
seconds after it has been switched off.
Let the motor come to a complete standstill
before setting the tool down.
5. USING THE BLOwER (See Fig. E)
The blower is intended for residential use
only. Use the blower outdoors to move
debris from hard surfaces. This blower is not
designed to clear leaves from large grassy
areas, or move wet, heavy debris.
USER TIPS
- Hold the blow tube approx 180mm above
the ground when operating the tool.
Use a sweeping motion from side to side.
Advance slowly keeping the accumulated
debris/leaves in front of you.
- After blowing the debris/leaves into a pile,
it is easy to dispose of the pile.
CAUTION!
Do not blow hard objects such as
-
nails, bolts, or rocks.
Do not operate the blower near
-
bystanders or pets.
Use extra care when cleaning debris
-
from stairs or other tight areas.
wear safety goggles or other suitable
-
eye protection, long pants, and shoes.
13
En