Haier HLE172 Mode D'emploi page 20

•The plug socket is functioning fine. To check this, plug another electrical appliance in to see if
the socket is faulty.
If the appliance is working, but not very well, check:
•The appliance is not overloaded.
•The thermostat is set to an appropriate temperature.
•The doors are closing properly.
•The cooling system at the rear of the appliance is clean and free of dust, and not touching
the rear wall.
•There is enough ventilation at the side and rear walls.
•This can be due to the decor door(s) not being properly fitted,
causing the fridge door to not close properly thus letting warm
air in. If you are at all unsure, ask your fitter to check the decor
doors.
If the appliance is noisy, check:
•The appliance is level and stable.
•The side and rear walls are clear, and there is nothing resting
on the appliance.
•Note: The cooling gas in the refrigerator may make a slight
bubbling or gurgling noise, even when the compressor is not
running.
If the appliance is beeping, check:
•That the door is closed. An alarm will sound after 60 seconds of a door being open.
If there's water in the base of the refrigerator compartment, check:
•The drain hole at the back of the compartment is clear.
If ice has formed on the back wall of the fridge:
•It is normal for some ice droplets to form on the back wall of the fridge. This does not
constitute a fault with the appliance.
•Ensure that no items inside the fridge are in contact with the back wall.
•Check that there is some resistance when opening the door of the appliance. If it opens at
the slightest touch it may mean that the door seal needs to be replaced.
•Check the door seal for any kinks, debris or damage. If you notice any, and are unable to
resolve the issue yourself, contact Customer Care so that the seal can be replaced.
•This can be due to the decor door(s) not being properly fitted. If you are at all unsure, ask
your fitter to check the decor doors.
If the LED unit within the appliance is not working:
•Contact Customer Care to arrange a service visit.
Installation preparation
This appliance must never be installed close to heat
sources, e.g. heating elements or cookers, nor in damp
places.
Seek the help of another individual, or two, when installing
this appliance. This appliance may have sharp edges. Wear
adequate PPE for the task and environment.
18