Helite Airbag E02 Manuel D'utilisation page 41

41
The logo certifies that the product complies with the requirements of EU
Regulation 2016/425. The EU declaration of conformity can be consulted on helite.com.
The CDU electronic card with the remote HMI is certified IEC 62368-1 / EN-62368-1
/ UL62368-1 / CSA62368-1 by TÜV Rheinland (Tillystr. 2, 90431 Nürnberg, Germany)
notified body no. 0197.
Helite declares that the CDU electronic card complies with the essential
requirements and other relevant provisions of the RED (Radio Equipment Directive)
2014/53/EU and RoHS 2011/65/EU.
ISED Statement:
For general products, this device contains licence-exempt transmitter(s) that comply
with Innovation, Science and Economic Development Canada's licence-exempt
RSS(s). Operation is subject to the following two conditions:
(1) this device may not cause interference ;
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
FCC Statement:
For general product, this device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference;
(2) this device must accept any interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.