Télécharger Imprimer la page

Costway NP10854 Mode D'emploi page 8

Foyer à gaz extérieur

Publicité

Les langues disponibles

Les langues disponibles

Step 3:
Locate the battery, remove the plastic cover first. Unscrew the rubber cap
of the Electric Ignitor, place one AA battery into the battery case. Make
sure the positive pole ("+") towards the cap. Screw the cap back to the
battery case tightly.
Step 4:
Place the lava rocks evenly onthe
top of the firebowl.
NOTICE: * Do not place lava
rocks on the screen.
* To ensure proper function, the
Guard on the Burner should never
have lava rocks covered over it.
Step 5:
DO NOT COVER THE
IGNITION SCREEN when
placing the lava rocks into
the fire bowl. Always keep
Ignition SCREEN visible.
** Connect the
Pressure-Regulating Valve
to the gas tank.
14
Guard
DO NOT PLACE FIRE
GLASS ON THE GUARD.
KEEP GUARD CLEAN.
CORRECT
INCORRECT
PRESSURE
RELIEF VALVE
CYLINDER VALVE
BLACK COUPLING NUT
turn clockwise to connect
REGULATOR
Step 6:
Turn the cylinder valve clockwise to close the gas supply on the gas tank.
Step 7:
Screw Regulator Coupling clockwise by hand only. Make sure it is
fastened.
Operation of Fire Table
LIGHTING INSTRUCTIONS
1. Turn the cylinder valve on the gas tank counter-clockwise to open the
gas supply.
2. Close the storing door on the firebowl for the gas tank.
3. Press and hold the Electric Ignitor. Meanwhile, push and turn the
Control Knob counter-clockwise to the "LOW" position. Keep pushing the
Control Knob to light the burner .
4. After ignition, release the Electric Ignitor. Continue to push and hold the
Control Knob for 45 seconds.
5. If ignition does NOT immediately take place in seconds, push and turn
the Control Knob clockwise to "OFF". Wait 5 minutes, then repeat the
lighting procedure as above.
6. If the burner does not ignite with the valve open, gas will continue to
flow out of the burner and could accidently ignite with risk of injury.
BLEED-OFF
VALVE
turn clockwise
to reseal
OFF
LOW
IGNITER-PUSH
H I G H
15

Publicité

loading