Publicité
Les langues disponibles
Les langues disponibles
● Before cleaning, always disconnect the pump from the power source.
● Disassemble the pump by removing the filter and regulator/impeller
plate. Remove the impeller/rotor assembly by gently pulling on the
impeller blades. Use a soft cloth or brush to clean the area inside of the
pump housing. Clean the filter, gland and impeller in warm soapy water.
● Although it is not required, pumps generally last longer if left running
continuously as it reduces the wear from starting and stopping.
However,running the pump continuously will also use a little more
electricity, and will require you to refill the fountain more frequently.
If mosquitoes are a problem in your area, it is recommended to run the
fountain as much as possible to prevent standing water, where
mosquitoes breed. You may also add a few drops of anti-mosquito water
treatment, available at your local home and garden store, to the fountain
water
● Place the fountain in a location that will not be damaged should the
area come in contact with liquids.
● Place the fountain in a location that will not be damaged should the
area come in contact with liquids.
● If the fountain is not in use for an extended period of time, disconnect
the power and empty all the water from the fountain. Do not tip the
fountain to empty the water. Use a small bucket.
● The fountain should not be operated in temperatures below 41°
Fahrenheit / 5° Celsius to prevent frost damage. During winter months,
before the temperature hits freezing, disconnect the power, drain your
fountain and store it in a heated area. If the fountain is stored outdoors in
freezing temperature, disconnect the power, empty all the water from the
fountain, remove the pump and any lights if possible, make sure it is
completely dry and cover it with a tarpaulin. Any water left in the fountain
may freeze and expand causing the fountain to crack.
20
Maintenance & Storage of Fire Table
To enjoy years of outstanding performance from your heater, make
sure you perform the following maintenance activities on a regular
basis:
● Before performing any maintenance always disconnect propane gas
tank.
● Use warm soapy water for cleaning. Never use flammable or corrosive
cleaning agents.
● Keep the heating item free and clear from combustible materials.
● Visually inspect burner for obstructions and keep tank enclosure free
and clear from debris.
● Use a soft brush to get rid of the mild stains, loose dirt and soil after the
burner and pumice stones/lava rocks/fire glassc om pletely cooled down.
Wipe down with a soft cloth.
● Harsh weather conditions may cause stubborn stains, discoloration and
possibly rust pitting.
● Permanent damage may occur if powder or solvent comes in contact
with painted or plastic components on this heating unit.
● Keep the heating unit stored away from direct sunlight.
● If storing this unit inside, disconnect the propane gas tank from the gas
valve.
● Not using manufacturer approved or supplied parts/accessories may
result in a defective condition.
● Always place lid (if applicable) or protective cover on heating item when
not in use. Turn control knob OFF.
NOTE: In a salt-air environment (such as near to ocean),
corrosion occurs more quickly than normal. Frequently check for
corroded areas and repair them promptly.
21
Publicité
