LaserLiner AutoSmart-Laser Mode D'emploi page 10

Special product features and functions
The rotary laser aligns itself automatically. It is set to the
required initial position (to within an operating angle of ± 4°) and the
automatic system then performs the necessary fine adjustment, with
three electronic measurement sensors detecting the X, Y and Z axes.
Transport LOCK: The device is protected by a special
motor brake during transport.
Space grids: These show the laser planes and functions.
auto =
Automatic
alignment
Inserting the batteries
Ensure correct polarity. The batteries must
be replaced if the status indicator (C) starts
to flash.
Horizontal levelling and vertical levelling
– Position the device on a level surface or on a tripod, horizontal or vertical.
– Press the "ON/OFF" switch.
– The device levels itself automatically to within a range of ± 4°. During
the set-up phase, the laser flashes and the prism head remains stationary.
When levelling is complete, the laser lights up continuously and rotates at
maximum speed.
If the device has been placed on a surface with too much of a slope
!
(more than 4°), the prism head remains stationary and the laser starts
to flash. The device must then be placed on a more even surface.
10
GB
auto auto
Horizontal Vertical
levelling levelling
90° angle Plumb
function