Publicité
Les langues disponibles
Les langues disponibles
4. Getting Started
4.1.
End position programming
Home screen on initial power-up.
This screen will no longer appear after the first initialization
Switch rep 13 in position 2: Manual mode.
Allows to rotate the motor without programming the limit
switch sensors
Allows to check the working of the motor sensor
Allows to check the cabling: when you turn the key on
open, the cover must open the swimming pool. If not,
reverse the motor wires.
Switch rep 13 in position 1: Initialization mode.
After exiting the manual mode, you must set the limit switches by
switching to the initialization mode:
1. press and hold the switch position 2 for 3 seconds. A
countdown appears.
2. After that, you can open to the open position.
3. To confirm the position, press position I briefly.
Switch rep 13 in position 0: Normal mode.
After initialization, with the key you can open and close the pool
between the open and closed positions defined during
initialization.
100% : pool open
0% : pool close
77.5121.0001
(1/29/2021)
ENGLISH
12/24
Publicité
