Toro SnowMax 724 QXE Manuel De L'utilisateur page 17

Inspecting the Throwing
Edges
Service Interval: Yearly—Inspect the throwing edges
and have an Authorized Service
Dealer replace the throwing edges
and scraper if necessary.
Before each session, inspect the throwing edges
for wear. When a throwing edge has worn down to
the wear-indicator hole, have an Authorized Service
Dealer replace the throwing edges
Figure 20
1. The wear-indicator hole
is intact; you do not need
to replace the throwing
edges.
Changing the Engine Oil
Service Interval: After the first 2 hours
Yearly
If possible, run the engine for a few minutes before
changing the oil to warm it. Warm oil flows better and
carries more contaminants.
Engine Oil Specifications
Engine oil capacity
Oil viscosity
API service classification
1. Move the machine to a level surface.
2. Place an oil-drain pan under the oil-drain plug,
remove the oil-drain plug, and tip the machine
All manuals and user guides at all-guides.com
(Figure 20).
g030128
2. The wear-indicator hole
is exposed; replace both
throwing edges.
0.50 L (17 fl oz)
Refer to Figure 22.
SJ or higher
backward and drain the used oil in the oil-drain
pan (Figure 21).
1. Oil-drain plug
3. After draining the used oil, return the machine to
the operating position.
4. Install the oil-drain plug and tighten it securely.
5. Clean around the oil-fill cap.
6. Use Figure 22
the outdoor temperature range expected:
15
Figure 21
to select the best oil viscosity for
Figure 22
g030122
g013802