Stihl HL 94 Notice D'emploi page 17

1
Shut off the engine.
N
Fit the blade scabbard.
N
Pull back the sliding sleeve (1) and
N
use the lever (2) to swing the joint
upwards – in direction of drive tube
– until the cutter bar is flat against
the drive tube.
Release the sliding sleeve (1) and
N
make sure the lock pin engages the
quadrant (3).
HL 94
Fitting the Harness
3
Some versions of the machine can be
carried on a shoulder strap.
2
The type and style of the shoulder strap
depend on the market.
Shoulder Strap
Put on the shoulder strap (1).
N
Adjust the length of the strap.
N
With the power tool attached, the
N
carabiner (3) must be at about the
same height as your right hip.
Attaching Machine to Shoulder Strap
N
1
Disconnecting Machine from Shoulder
Strap
3
N
Throwing Off the Machine
The machine must be quickly thrown off
in the event of imminent danger.
Practice removing and putting down the
machine as you would in an emergency.
To avoid damage, do not throw the
machine to the ground when practicing.
2
1
2
Attach the carabiner (1) to the
carrying ring (2) on the drive tube –
hold the carrying ring steady.
1
2
2
Press down the bar on the
carabiner (1) and pull the carrying
ring (2) out of the carabiner.
WARNING
English
1
1
15