Publicité
Les langues disponibles
Les langues disponibles
DUCTED INSTALLATIONS
1. For rear ducted installations, attach the rear chimney
transition to the top of the rangehood (FIGURE 8) with the
4 screws provided.
2. If installing the hood with ductwork venting up thru the
ceiling (not to the rear of the hood thru the wall ) , then the
optional chimney covers (purchased separately) can be
attached over the ductwork. Please call 508-358-5353 for
instructions on attaching chimney covers.
FIGURE 8
DUCTLESS INSTALLATIONS
1. Screw the ductless grille to the top duct with 4 screws
(part C using the E screws in FIGURE 9).
2. Attach the grille cover (H in FIGURE 9) using the cover
screws (I in FIGURE 9).
3. Attach one charcoal filter to each end of the blower. Each
charcoal filter attaches to the grid on the side of the blower.
Rotate the filter clockwise to install and counterclockwise to
remove (as indicated in FIGURE 10).
C
FIGURE 9
FIGURE 10
All manuals and user guides at all-guides.com
I
H
E
FOR ALL INSTALLATIONS
1. Install the grease filters (as indicated in FIGURE 6)
2. Place the 4 ducting panels back onto the hood
(as indicated in FIGURE 5)
3. Turn the power supply on. Turn on blower and lights. If the
rangehood does not operate, check that the circuit breaker
is not tripped or the house fuse blown. If the unit still does
not operate, disconnect the power supply and check that the
wiring connections have been made properly.
USE AND CARE INFORMATION
This rangehood system is designed to remove smoke, cooking
vapors and odors from the cooktop area.
For Best Results
Start the rangehood several minutes before cooking to develop
proper airflow. Allow the unit to operate for several minutes
after cooking is complete to clear all smoke and odors from the
kitchen.
Remote Control
The rangehood can be controlled using the enclosed remote
control which has the control layout (indicated in FIGURE 14 on
the next page). The remote uses alkaline AAA type batteries.
To replace the batteries, remove the cover by removing the
screw and sliding off the cover (as indicated in FIGURE 11).
Do not place the remote control close to heat sources.
FIGURE 11
Cleaning
The stainless steel grease filters should be cleaned frequently in
hot detergent solution or washed in the dishwasher. Stainless
steel cleaner should be used on stainless rangehoods.
Abrasives and scouring agents can scratch stainless steel
finishes and should not be used to clean finished surfaces.
The inside of the ducting panels (FIGURE 12) should be
cleaned with a damp cloth and a neutral dish detergent. Do
not use wet sponges or cloths or jets of water; do not use
abrasive substances.
FIGURE 12
Publicité
