Generac Mobile Link Manuel D'installation Et D'utilisation page 9

Section 3 Operation and Troubleshooting
3.1 — Installation
NOTE:
Verify generator operation and performance before
adding Mobile Link during a new generator installation.
1. Unlock both locks, open generator lid and remove
front panel.
2. Turn the generator to OFF. Remove generator panel
fuse.
NOTE:
There are different controller configurations for
various model years.
3. Turn the main utility disconnect breaker in the home's
electrical panel to OFF or OPEN.
4. Remove T1 fuse from transfer switch.
5. Disconnect battery negative (-) cable, then positive (+)
cable.
NOTE:
The battery divider will need to be removed for
installation on PowerPact units.
6. Remove controller sheet metal cover and fasteners.
7. Attach provided template to position mounting hole
location. Mounting hole location is critical for proper
operation. Mobile Link unit antenna must protrude 1
inch above top of generator roof when installation is
complete.
NOTE:
2013 and later models have a prepositioned dimple
on the enclosure to mark the center of the hole.
Figure 3-1.
8. Inspect area behind external breaker box to verify all
wires are moved out of the way to prevent damage
during drilling.
9. Use template provided with these instructions to make
a 1 1/8" hole just behind the breaker box.
10. Route six pin connector through plastic fitting and one
green gasket. See A and B in Figure 3-2.
11. Insert plastic fitting, from inside of generator, through
newly drilled hole in generator wall. Position threaded
portion of fitting towards outside.
12. Install second green gasket on outside of enclosure.
13. Thread antenna (D) into Mobile Link unit (C). Turn
antenna clockwise until secure. Position antenna
pointing up.
Owner's/Installation Manual for Mobile Link
NOTE:
Do not over-tighten. Hand tighten only.
14. Insert six pin connector into Mobile Link unit. Connec-
tor will only fit one way. DO NOT force into place.
15. With plug installed, tighten plastic fitting and draw
Mobile Link unit to generator wall. Do not over tighten.
Position Mobile Link unit with antenna facing upwards.
NOTE:
Hold Mobile Link unit firmly and tighten nut during
installation to avoid damage to unit wiring harness.
000194
16. Route harness along wire shelf with other wire looms.
Position harness with other wire looms to provide addi-
tional support.
NOTE:
On 2008 Home Standby Units only, remove fasten-
ers that secure controller.
17. Lift controller to gain access to accessory plug loca-
tion.
NOTE:
If there is a decal labeled "Port 1", remove decal to
locate connector. If there is no decal, locate the open eight
pin connector on underside of generator controller.
18. Install harness eight pin connector into open socket on
controller.
NOTE:
The connector will only fit one way. DO NOT force.
Operation and Troubleshooting
D
C
B
A
Figure 3-2.
Figure 3-3.
000195
000194
5