Generac Mobile Link Manuel D'installation Et D'utilisation page 7

Section 2 General Information
2.1 — Introduction
The Mobile Link remote monitoring system allows generator
status to be monitored from anywhere the owner has access to
an Internet connection. Every effort was made to ensure that
the information and instructions in this manual were both accu-
rate and current at the time the manual was written. However,
the manufacturer reserves the right to change, alter or other-
wise improve this product or manual at any time without prior
notice.
The unit is mounted on the outside of the generator and com-
municates with the generator's controller via a serial port.
The Mobile Link remote monitoring system provides information
about the generator. When the generator is registered with
www.MobileLinkGen.com, owners can log onto this website to
check on the current status of the generator at any time. It will
also notify the owner of any change in operating status. The
owner will be contacted if alarms or warnings occur. When a
0K2220
0K2231
Owner's/Installation Manual for Mobile Link
Wire Harness Part Numbers
Used on Generac Home Standby Generators
Used on Generac Commercial Generators
change in the generator's status occurs, an e-mail or text mes-
sage is sent. The delivery method and frequency of these alerts
can be adjusted on the website.
2.2 — Network Extender
If cellular coverage is not adequate for communication signal
strength, a network extender is available through any Verizon
equipment provider.
2.3 — Website Information Screens
The Mobile Link unit will provide alerts when maintenance is
required, according to the scheduled maintenance intervals for
the generator. The generator's total run hours can be viewed
and a log of completed maintenance can be established.
The exercise time of the generator can be checked and altered
through the MobileLinkGen.com website without having to
step foot outside the comfort of the home.
General Information
3