Generac Mobile Link Manuel D'installation Et D'utilisation page 10

Operation and Troubleshooting
19. For Nexus or Sync controllers, locate the port on the
under side or the controller. It may be covered with a
decal. If so, remove the decal and install the harness.
NOTE:
For units equipped with the Evolution or Sync 2.0
controllers, the accessory port is located underneath the
controller and is covered with a decal that says "Accessory
Prt 1". Remove the decal and install the harness.
NOTE:
On PowerPact models, the accessory port is
located under the controller, and visible through the bat-
tery door after the plate is removed.
Figure 3-4.
NOTE:
The harness power wires consist of a black nega-
tive (-) wire and a fused yellow positive (+) wire.
20. Loosen and remove nuts from both positive (+) and
negative (-) terminal screws on battery cables. Slide
wires over terminal screws and replace nuts. Connect
positive (+) battery cable and tighten securely. Then,
install and tighten the negative (-) cable.
21. Install controller panel and sheet metal controller
cover. Install and tighten retaining fasteners.
22. Put generator in OFF position.
23. Install generator controller fuse.
24. Install T1 fuse into transfer switch.
25. Turn main breaker in the home electrical panel to ON.
On generator control panel, follow installation wizard
and validate correct date, time, etc.
26. Place generator in AUTO.
27. Turn utility disconnect switch OFF to simulate a power
outage. Generator should turn ON. Allow to run for
approximately 30 seconds, then turn utility disconnect
switch back to ON or CLOSED to restore utility ser-
vice. Transfer switch will trasfer back to utility. Genera-
tor will cool down and then shut down.
28. Verify Mobile Link unit middle LED is illuminated and
bottom LED is illuminated or flashing at this time.
NOTE:
Top LED will not illuminate until registration/acti-
vation process is complete.
6
A
B
C
A LED will illuminate when unit is registered.
B LED with flash if there is a poor connection.
000197
LED will be off if there is no network connection
C
LED will flash if the server connection is pending or
down.
Network Extender Installation
If cellular coverage is not adequate for communication signal
strength, a network extender is available through any Verizon
equipment provider.
1. Place network extender near the most centrally
located window. For best results place extender in an
elevated location such as the top of a book shelf or tall
cabinet. If already using a WIFI router, keep extender
at least 2 feet away.
2. Connect one end of the provided Ethernet cable to an
open port on the router and connect the other end to
the WAN port located at the rear of the network
extender.
3. Plug the power supply into the 12VDC power port
located at the rear of the network extender and plug
the supply into an available wall outlet.
Figure 3-5.
Owner's/Installation Manual for Mobile Link
000216