Generac Mobile Link Manuel D'installation Et D'utilisation page 4

Table of Contents
Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
1.This device may not cause harmful interference.
2.This device must accept any interference received, including
interference that may cause undesired operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
FCC Interference Statement (Part 15.105 (b))
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installa-
tion. This equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio com-
munications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one
of the following measures:
• Move the receiving antenna elsewhere, or adjust its posi-
tion.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
To comply with FCC/IC RF exposure limits for general popula-
tion / uncontrolled exposure, the antenna(s) used for this trans-
mitter must be installed to provide a separation distance of at
least 20 cm from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter.
RF Exposure (OET Bulletin 65)
To comply with FCC/IC RF exposure requirements for mobile
transmitting devices, this transmitter should only be used or
installed at locations where there is at least 20 cm separation
distance between the antenna and all persons.
iv
Section 7.1.5 of RSS-GEN
Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interfer-
ence that may cause undesired operation of the device.
Please record the following information on the front of this man-
ual:
•
MDN No. located on bottom of device or on packaging.
•
MEID No. located on packaging.
•
Generator Serial No. located on the divider spanel near
the controller.
Owner's/Installation Manual for Mobile Link