Publicité
Les langues disponibles
Les langues disponibles
3. If base used previously with
iAnchor Advance seat remove
rebound bar as shown in illustration
8
!
Store safely for future use with
iAnchor Advance seat.
9
4. Press the ISOFIX release button on
either side of the base, then pull
out the ISOFIX connectors.
5. Line up the ISOFIX connectors with
the ISOFIX guides, and then click
both ISOFIX connectors into the
ISOFIX anchor points.
11
!
Please consider that base MUST
be connected via ISOFIX to the
car. Attachment of base only with
car seat belt is not permitted
according to ECE R129. For a
safer drive of your child you are
free to decide on whether to
install the base with or without
car seat belt in addition to ISOFIX
attachment.
-1
11
!
Check to make sure the base is
securely installed by pulling on
the both ISOFIX connectors.
6. There are 9 adjustable positions for
ISOFIX. Press the ISOFIX release
button and push the base back
against the vehicle seat until tight.
9
All manuals and user guides at all-guides.com
8
2
1
9
10
10
2
11
1
7. After placing the base on the
vehicle seat, extend the load leg to
floor
, When the load leg
12
indicator shows green means it is
installed correctly, red means it is
installed incorrectly.
1
!
The load leg has 24 positions.
When the load leg indicator
shows red this means the load
leg is in the wrong position.
!
Make sure the load leg is in full
contact with the vehicle floor
pan.
!
Squeeze the load leg releasing
button, then shorten the load leg
upwards.
The completely assembled base is
shown as
13
!
The ISOFIX connectors must be
attached and locked onto the
ISOFIX anchor points.
1
!
The load leg must be installed
correctly with green indicator.
-2
13
8. Push the infant carrier module
down into the base
infant child restraint is secure, the
infant child restraint indicator
shows green.
12
-1
12
1
13
-1
13
14
14
, if the
15
15
2
1
10
Publicité
