Dimplex EMC4240 Manuel Du Propriétaire page 5

Grounding Instructions
This heater is for use on 240 Volts.
The cord has a plug as shown on
Figure 1. No adapter should be
used with this unit. The type outlet
is a 240 Volt grounding outlet. When
properly installed, it provides a ground
connection through the cord to the
heater to protect the operation from
electric shock.
Heater Location And
Clearances
The heater is intended for use
located on a hard floor, table top,
desk or on shelf, and the like.
The discharge air should wipe the
walls without blowing directly on
them (Figure 2).
Ensure the air discharge is
parallel to or away from walls.
! NOTE: To prevent personal
injury always use a licensed
electrician to install new
outlets or circuits.
CAUTION: When turning and/or tilting the heater do not block the
exhaust opening.
Use Of Support Stand (EMC4240 only)
The pre-installed support stand can be swivelled out to allow an
upward angle for the air discharge. When in down position, the heater
should be placed on a flat surface such that it will be stable and not fall
over (Figure 3).
All manuals and user guides at all-guides.com
Figure 1:
Plug and outlet
configuration for 240
Volt, 30 Amp circuit
Ground
Plug
Figure 2
Outside Wall
Outlet