Black & Decker EGBL108 Traduction Des Instructions Initiales page 9

Drilling/screwdriving
• Select forward or reverse rotation using
the forward/ reverse slider (2).
• To switch the tool on, press the switch
(1). The tool speed depends on how far
you press the switch.
• To switch the tool off, release the switch.
Hints for optimum use
Drilling
• Always apply a light pressure in a straight
line with the drill bit.
• Just before the drill tip breaks through
the other side of the workpiece, decrease
pressure on the tool.
• Use a block of wood to back up
workpieces that may splinter.
• Use spade bits when drilling large
diameter holes in wood.
• Use HSS drill bits when drilling in metal.
• Use masonry bits when drilling in soft
masonry.
• Use a lubricant when drilling metals other
than cast iron and brass.
• Make an indentation using a centre
punch at the centre of the hole to be
drilled in order to improve accuracy.
Screwdriving
• Always use the correct type and size of
screwdriver bit.
• If screws are difficult to tighten, try
applying a small amount of washing
liquid or soap as a lubricant.
• Always hold the tool and screwdriver bit
in a straight line with the screw.
Maintenance
Your BLACK+DECKER tool has been
designed to operate over a long period of
time with a minimum of maintenance.
Continuous satisfactory operation depends
upon proper tool care and regular cleaning.
All manuals and user guides at all-guides.com
(Original instructions)
Your charger does not require any
maintenance apart from regular cleaning.
Warning! Before performing any
maintenance on the tool, remove the battery
from the tool. Unplug the charger before
cleaning it.
• Regularly clean the ventilation slots in
your tool and charger using a soft brush
or dry cloth.
• Regularly clean the motor housing using a
damp cloth. Do not use any abrasive or
solvent-based cleaner.
• Regularly open the chuck and tap it to
remove any dust from the interior.
Batteries
Run the battery down completely,
then remove it from the tool.
• NiCd, NiMH and Li-Ion batteries are
recyclable. Take them to any authorised
repair agent or a local recycling station.
Technical data
Voltage
No-load speed
Max. torque
Chuck capacity
Max Drilling capacity
Steel/wood
Charger
Input Voltage
Output Voltage
Current
Approx. charge time
Battery
Voltage V
DC
Capacity Ah
Type
ENGLISH
EGBL108
V 10.8
DC
Min -1 0-600
Nm 12/24
mm 10
mm 10/25
V 230
AC
V 10.8
DC
A 2.0
min 30
BL1110 BL1310 BL1510
10.8 10.8 10.8
1.1 1.3 1.5
Li-Ion Li-Ion Li-Ion
9