Krups KM600 Manuel D'instructions page 5

• Children must not use the appliance as a toy.
• *The temperature of the accessible surfaces may be high when the appliance
is in operation. Do not touch the hot surfaces of the appliance.
• The coffee-maker shall not be placed in a cabinet when in use.
• Before plugging in the appliance, ensure that the power supply corresponds to
that of the appliance. Also check that the current includes an earthed socket.
• The guarantee will not apply in the event of faulty connection to a power supply.
• When using the appliance, always place it on a flat, stable, heat resistant work
surface away from water splashes and any sources of heat.
• Unplug the appliance if you do not intend to use it for a prolonged period and
during cleaning.
• Do not use the appliance if it is not working correctly or if it is damaged. In this
case, contact an approved service centre.
• Do not leave the appliance unattended whilst in operation.
• Cleaning and standard maintenance may be carried out by the customer; any
other servicing must be carried out by an approved service centre.
• The power cable must never be in proximity to or in close contact with the heated
elements of your appliance, close to a source of heat or a sharp edge.
• For your safety, only use accessories and spare parts designed for your
appliance.
• Do not remove the plug from the socket by pulling on the cord.
• Do not use the pot in a microwave oven, on a flame or on electric cooking plates.
• Do not fill the appliance with water if it is still hot.
• All appliances are subject to strict quality controls. Practical performance tests
are conducted on appliances picked out by chance, which explains any possible
signs of use.
• When the coffee machine is in use, always close the lid.
• Do not use the coffee pot without the lid.
• Do not pour hot water into the tank.
ENVIRONNEMENT
Environment protection first!
Your appliance contains valuable materials which can be recovered or
recycled.
Leave it at a local civic waste collection point.
6
DESCRIPTION
A Appliance body
B Lid
C Water container
D Water level gauge
E Carafe lid
F Carafe handle
G Carafe
H Heating plate
PROGRAMMING THE CLOCK
„ Place the coffee maker on a hard, flat surface.
„ Plug the power cable into a 220V-240V wall outlet.
– When you plug in the coffee maker for the first time, 12:00 AM appears and blinks on the
screen. Fig. 1. Set the hour by pressing the CLOCK button (O), then the HR button (L)
for the hours and MIN (M) button for the minutes. The time appears. It is automatically
confirmed after 5 seconds have elapsed or by pressing the CLOCK button (O).
Note: Your clock is now set and will continue to display the current time even when your
appliance is in standby mode. If you want to set the time again, press the CLOCK (O) button
and repeat the steps above.
If the unit is unplugged or if there is a power failure, the clock will return to 12:00 AM. The
above instructions must be repeated to program the clock again.
BEFORE USING FOR THE FIRST TIME
„ Remove the stickers from the machine.
„ Prior to first use, run your coffee maker without any coffee to rinse the circuit. Fill the
water reservoir up to the maximum level and start a cycle by pressing on the ON/OFF
button (J).
IMPORTANT: Your appliance has been designed to operate using only cold or warm water.
COFFEE PREPARATION
„ Lift the coffee maker's lid (B). Fig. 3.
„ Fill the carafe (G) with cold or warm water. Pour water in the water tank (C) Fig. 4.
„ The number of cups is indicated by marks on the carafe and by the water level indicator.
Do not exceed 10-15 cups. Fig. 5.
„ Place the carafe (G) with its lid (E)closed on the heated base (H) by ensuring that it is
properly in place in order to activate the mechanism that allows the coffee to flow. Fig. 8.
„ Make sure that the filter holder (I) is inserted. Fig. 6. Place the filter paper into the filter
holder (I). Make sure that the filter paper is fully open and properly in place in the filter
holder. Fig. 7.
„ Should some ground coffee be inadvertently poured into the reservoir, refrain from starting
the cycle and first clean the reservoir.
I Filter holder
J ON/OFF button
K PROG button
L HR button
M MIN button
N AROMA button
O CLOCK button
P Spoon
7