Waring Commercial WSB33XE Mode D'emploi page 3

Correct Disposal of this Product
This marking indicates that this product should not be disposed of with
other household wastes throughout the EU. To prevent possible harm
to the environment or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the return and
collection systems or contact the retailer where the product was
purchased. They can take this product for environmentally safe recycling.
TO ENSURE PROPER USE OF THIS UNIT, PLEASE SEE IMPORTANT GROUNDING
INSTRUCTIONS. PRIMARY COUNTRIES USING THE DIFFERENT PLUG TYPES ARE
LISTED FOR REFERENCE ONLY. REFER TO THE ACTUAL UNIT TO DETERMINE
WHICH PLUG TYPE IS APPLICABLE.
TYPE F PLUG
This grounded plug has two round prongs and there
are two grounding clips on the sides of the socket.
(GERMANY, AUSTRIA, NETHERLANDS,
This plug is non-polarized so the plug can be inserted
SWEDEN, NORWAY, FINLAND,
in either direction into the socket. Grounding is
PORTUGAL, SPAIN, EASTERN EUROPE)
accomplished when the clips on the socket meet
the contact on the plug. Ensure that the plug is fully
inserted.
TYPE G PLUG
This grounded plug has three rectangular prongs that
form a triangle. Line up the prongs to the socket and
(UNITED KINGDOM, IRELAND,
ensure that the plug is fully inserted. This plug is also
CYPRUS, MALTA, MALAYSIA,
fuse-protected for power surges.
SINGAPORE AND HONG KONG)
TYPE I PLUG
This grounded plug has two flat pins in a V-shape as
well as a grounding pin.
(ARGENTINA, AUSTRALIA, CHINA,
NEW ZEALAND, PAPUA NEW GUINEA)
TYPE C PLUG
This electrical plug is a two-wire plug that has two
round pins. It fits into any socket that accepts 4.0 –
– 2 PRONG
4.8 mm round contacts on 19 mm centres.
(BRAZIL)
4
SPECIFICATIONS
• RATINGS 220-240 V, 50Hz
• MOTOR w/RFI Suppression 2 speed II (HI) 20,500 +/-500RPM's
• Shaft/Blade Guard Stainless Steel
• Cord 6 feet (Exposed) VDE recognised H03VVH2-F with
VDE plug for E models and UK plug for K models
• CE Listed
THE PARTS
1. Cord Wrap
2. Speed Control (2-speed switch)
3. Motor Base/Handle
4. Stainless Steel Shaft
5. Stainless Steel
Protective Blade Guard
6. Metal Blade
(not shown)
BEFORE YOU BEGIN
NOTE: Always unplug the Waring™ Immersion Blender before
cleaning the metal blade.
Before using the Immersion Blender, Waring
unit with a clean, damp cloth to remove any dirt or dust. Place the metal blade
end of the hand blender under running water to rinse it.
Dry thoroughly with a soft absorbent cloth. Read all instructions completely
for detailed operating procedures.
I (LO) 15,500 +/-500RPM's
1.
2.
3.
4.
5.
6.
suggests that you wipe the
™
5