Dimplex Ignite 50 Mode D'emploi page 15

Operation
R e m o t e C o n t r o l B a t t e r y
Replacement
To replace the Battery:
1. Slide battery cover open on the
remote control.
2. Correctly install one 3 Volt
(CR2032 [longer life] or
CR2025) Battery in the
battery holder.
3. Close the battery cover.
Battery must be recycled or
disposed of properly. Check with
your Local Authority or Retailer
for recycling advice in your area.
All manuals and user guides at all-guides.com
should not be operated with an
accumulation of dust or dirt on or in
the unit, as this can cause a build
up of heat and eventual damage.
For this reason the heater must
be inspected regularly, depending
upon conditions and at a minimum
yearly intervals.
Partially
Cleaning
The partially reflective glass is
cleaned in the factory during
the assembly operation. During
shipment, installation, handling,
etc., the partially reflective glass
may collect dust particles; these
can be removed by dusting lightly
with a clean dry cloth.
To remove fingerprints or other
marks,
glass can be cleaned with a damp
cloth. The partially reflective glass
should be completely dried with
a lint free cloth to prevent water
spots. To prevent scratching, do
not use abrasive cleaners.
Maintenance
  WARNING: Disconnect power
and allow heater to cool before
attempting any maintenance or
cleaning to reduce the risk of
fire, electric shock or damage to
persons.
!
NOTE:
The
Reflective
the partially
fireplace
Glass
reflective
15