Publicité
Les langues disponibles
Les langues disponibles
EN
17
Rear Wheel - Bolt-on Removal
1.If the bicycle has rim brakes, make sure the brakes are loose
enough to allow the wheel to pass through the brake pads easily.
For disc brakes, no adjustment is required.
2.Most bikes have a plug or quick-disconnect box located on the
seat stay or chain stay. These allow the motor to be easily
disconnected from the controller. Simply undo the single large
plug or open the black plastic box and undo the five plugs inside.
3.With the bicycle in a stand or upside-down, loosen the axle nuts
then remove the wheel from the bicycle.
All manuals and user guides at all-guides.com
DRIVETRAIN
The drivetrain of a bicycle refers to all parts that transmit power to
the rear wheel including the pedals, chain, chainwheel, crank set and
freewheel.
PEDALS
Pedals are available in a very of shapes, sizes and materials, and
each are designed with a particular purpose in mind. Some pedals
can be fitted with toe clips and traps. These help to keep the feet
correctly positioned and allow the rider to exert pulling force, as well as
downward pressure, on the pedals. Use of toe clips with straps requires
practice to acquire the necessary skill to operate them safely.
Inspection
Pedals should be inspected every month, taking note of the following
areas:
- Check correct tightness into the crank arm.
Allowed to become loose, they will not only be dangerous but will
also cause irreparable damage to the crank.
- Check that pedal bearings are properly adjusted.
Please up and down, and right to left, and also rotate them by
hand. If you detect any looseness or roughness in the pedal
bearings then adjustment, lubrication or replacement is required.
- Ensure that the front and rear pedal reflectors
securely fitted.
- Also ensure that the toe clips, if fitted, are securely
the pedals.
Never ride with loose pedals.
EN
18
Publicité
