Hotpoint Ariston ARMXXL 125 Mode D'emploi page 3

Connecting the drain hose
! We advise against the use of hose extensions;
if it is absolutely necessary, the extension must
have the same diameter as the original hose and
must not exceed 150 cm in length.
Electrical connections
Before plugging the appliance into the electricity
socket, make sure that:
• the socket is earthed and complies with all
applicable laws;
• the socket is able to withstand the maximum
power load of the appliance as indicated in the
Technical data table (see opposite);
• the power supply voltage falls within the values
indicated in the Technical data table (see opposite);
• the socket is compatible with the plug of the
washing machine. If this is not the case, repla-
ce the socket or the plug.
! The washing machine must not be installed
outdoors, even in covered areas. It is extremely
dangerous to leave the appliance exposed to
rain, storms and other weather conditions.
! When the washing machine has been installed,
the electricity socket must be within easy reach.
All manuals and user guides at all-guides.com
Connect the drain
hose, without bending
it, to a drainage duct or
a wall drain located at a
height between 65 and
100 cm from the floor;
alternatively, rest it on
the side of a washba-
sin or bathtub, faste-
ning the duct supplied
to the tap (see figure).
The free end of the
hose should not be
underwater.
! Do not use extension cords or multiple sockets.
! The cable should not be bent or compressed.
! The power supply cable must only be replaced
by authorised technicians.
Warning! The company shall not be held responsible
in the event that these regulations are not respected.
The first wash cycle
Once the appliance has been installed, and
before you use it for the first time, run a wash
cycle with detergent and no laundry, using the
wash cycle 1.
Technical data
Model ARMXXL 125
width 59.5 cm
Dimensions height 85 cm
depth 53,5 cm
from 1 to 7 kg for the wash
programme;
Capacity
from 1 to 5 kg for the drying
programme
Electrical please refer to the technical
data plate fixed to the machine
connections
maximum pressure 1 MPa
(10 bar)
Water con-
minimum pressure 0.05 MPa
nections
(0.5 bar)
drum capacity 52 litres
Spin speed up to 1200 rotations per minute
Wash: programme 6; tempera-
ture 60°C; using a load of 7 kg.
Drying: first drying cycle perfor-
Energy rated
programmes med with a 2 kg load, by selec-
according to ting the
EN 50229 The second drying cycle is per-
formed with a 5 kg load, by se-
lecting the
This appliance conforms to
the following EC Directives:
- 2004/108/CE (Electroma-
gnetic Compatibility) and
subsequent modifications
- 2012/19/EU
- 2006/95/EC (Low Voltage)
dryness level.
dryness level.
3
GB