Publicité
Les langues disponibles
Les langues disponibles
Figure 1C – Wheel Assembly
1.2.2 BATTERY CABLE CONNECTION (ELECTRIC START
ONLY)
The unit has been deliberately shipped with the battery cables
disconnected. You will need two 8mm wrenches to secure the
battery cables.
To connect the battery (see Figure 14 for connection details):
1. Cut off cable ties securing battery cables.
2. First, connect the red cable to the positive (+) battery terminal
with the supplied bolt.
3. Connect the black cable to the negative (-) battery terminal
with the supplied bolt.
4. Make sure all connections are secure. Slide the rubber boots
over the terminals and connection hardware.
If the battery is unable to start the engine, charge it with the
12V charger included in the accessory box (see the "Charging a
Battery" section for details).
NOTE:
1.3 EMISSIONS INFORMATION
The Environmental Protection Agency (and California Air Resource
Board for generators certified to CA standards) requires that
this generator comply with exhaust and evaporative emission
standards. Locate the emissions compliance decal on the engine
to determine what standards the generator meets, and to determine
which warranty applies. This generator is certified to operate on
gasoline. The emission control system includes the following
components (if equipped):
• Air Induction System
– Intake Pipe / Manifold
– Air Cleaner
• Fuel System
– Carburetor
– Fuel Tank / Cap
– Fuel Lines
– Evaporative Vent Lines
– Carbon Canister
• Ignition System
– Spark Plug
– Ignition Module
• Exhaust System
– Exhaust Manifold
– Muffler
– Pulsed Air Valve
– Catalyst
General Information
5
Publicité
