Publicité
Les langues disponibles
Les langues disponibles
General Information
1.1 UNPACKING
• Remove all packaging material.
• Remove separate accessory box.
• Remove the generator from carton.
1.1.1 ACCESSORY BOX
Check all contents. If any parts are missing or damaged, locate an
authorized dealer at 1-855-GEN-INFO.
• 1-Owner's manual
• 1-Bottle of Oil SAE 30
• 3-Product Registration Cards (English, Spanish, French)
• 1-Oil Funnel
• 4-Carriage Bolts (A)
• 4-Acorn Nuts (B)
• 2-Small Washers (C)
• 2-Rubber Feet (D)
• 2-Foot Brackets (E)
• 2-M8-1.25 x 25.4 (F)
• 8-M8-1.25 x 16 (G)
• 10-M8 Nuts (H)
• 1-Axle (J)
• 1-Axle Bracket (K)
• 2-Wheels (L)
• 2-Large Washers (M)
• 2-Hair Pins (N)
• 1-Battery Charger (Electric start models)
1.2 ASSEMBLY
The generator requires some assembly prior to using it. If
problems arise when assembling the generator, please call the
Generator Helpline at 1-855-GEN-INFO.
1.2.1 ASSEMBLING THE ACCESSORY KIT
The wheels are designed to greatly improve the portability of the
generator. You will need the following tools to properly install the
accessory kit:
• Ratchet, a 10mm socket and a 13mm socket
• 10mm box wrench
Refer to the instructions below and figures 1A, 1B, and 1C to
install the handles, feet, and wheels. Note: the handle components
are already pre-assembled from the factory.
Handle (Figure 1A)
1. Install the handle assembly to the frame by using bolts (A) and
nuts (B).
2. Repeat step one for opposite handle.
Feet (Figure 1B)
3. Place washer (C) inside rubber foot (D). Secure parts to
bracket (E) with bolt (F) and nut (H).
4. Install foot assembly to the frame using the short bolts (G)
and nuts (H).
5. Repeat steps 3 & 4 for other foot.
4
Wheels (Figure 1C)
6. Use four short bolts (G) and four nuts (H) to secure the axle
(J) & bracket (K) to the frame.
7. Slide wheel (L) and washer (M) onto axle (J). Secure parts
with pin (N).
8. Repeat steps 6 & 7 for the opposite wheel.
Figure 1A – Handle Assembly
Figure 1B – Foot Assembly
F
E
G
D
C
H
Publicité
